Small form factor, IP 65-rated EMC cable entry system.
Oppenweiler-based Murrplastik Systemtechnik presents new KDP/N-EMC cable entry module. When used with the KDP/N cable entry plate, the KDP/N-EMC system makes short work of installing cabling into any housing. A key advantage: this is the first system from Murrplastik to offer EMC protection plus a high level of protection against environmental factors (protection class IP65) in a cable entry system.

KDP/N-EMV


Picture 1: KDP/N-EMC as an add-on module for the ground stage, in conjunction with the KDP/N models

(Click for high resolution image)


Innovative new sealing technology, which separates out the seal stage (KDP/N) from a discrete EMC ground stage (KDP/N-EMC), not only produces outstanding EMC characteristics but also enables the IP65-rated entry of cabling in a very small form factor. For this technical solution, Murrplastik engineers reached deep down into their box of engineering design tricks.

Attached immediately behind the IP 65-rated cable entry unit is an additional EMC ground stage in the form of a conductive rubber mat. This EMC ground stage discharges all cable shielding interference simply and safely to the ground via the switch cabinet.

KDP/N-EMV


Picture 2: This EMC ground stage discharges all cable shielding interference simply and safely to the ground via the switch cabinet.

(Click for high resolution image)



Radiated interference is discharged through the conductive elastomer and the stainless steel housing. The KDP/N-EMC is available in versions matching the existing hole patterns on the KDP/N 24/xx model cable entry plate. Cable diameters from 3–20 mm can be wired. When combined with the KDP/N, the KDP/N-EMC can be deployed in switch cabinet cut-outs for the 24-pin model plug connector from Harting und Wieland.


PRESS QUERIES
Murrplastik Systemtechnik GmbH
Dieselstraße 10
71570 Oppenweiler
Marketing Department
Günter Milla
Tel. 07191/482-845

guenter.milla@murrplastik.de
www.murrplastik.de

About Murrplastik Systemtechnik GmbH

Since its foundation in 1976, Murrplastik Systemtechnik GmbH has been one of the pioneers for high-tech plastic products. In 1984 the first open cable drag chain was patented in Oppenweiler. In 1986 Murrplastik Systemtechnik developed the first computer-aided labelling system for single wires, clamps and control gear. In 1993 Murrplastik Systemtechnik introduced the first cable entry systems. The latest development from the Swabian engineers caused quite a stir all over world: The first magnetic energy supply cables For the first time, travelling distances are now possible without contact between the upper and lower chain sections. This serves to eliminate wear and tear.

Up to now Murrplastik Systemtechnik GmbH has registered over 100 patents. This is enabled by an innovation culture that is deeply rooted in the company from apprentice level right up to the development department. Gaining the competitive edge through innovative means is one of the guiding principles of Murrplastik Systemtechnik. Murrplastik products are sold via branches in France, Italy, Switzerland, Spain, USA and China as well as representatives in Europe, North and South America, Africa, Australia and Asia.